-
Meltblown non woven fabric use polypropylene as the main raw material, and the fiber diameter can reach 0.5-10 microns. These ultra-fine fibers with unique capillary structure increase the number and surface area of fibers per unit area, so that the meltblown cloth has good air filtration. , is a relatively good mask material. In large, medium and small medical institutions, in disaster-stricken a...
read more
-
SMS non-woven is Spunbond + Meltblown + Spunbond Nonwovens. It is a composite product of spunbond and meltblown, with high strength, good filtration performance, no adhesive, Non-toxic and other advantages. Currently mainly used in medical and health labor protection products such as surgical gowns, surgical caps, protective clothing, surgical bags, etc. Gram weight range: 30-500 gsm; Basic ...
read more
-
1. Spunlace non-woven fabric The spunlace process is to spray high-pressure fine water flow onto one or more layers of fiber webs, so that the fibers are entangled with each other, so that the fiber webs are reinforced and have a certain strength. 2. Heat-sealed non-woven fabrics Thermally bonded non-woven fabrics refer to adding fibrous or powdery hot-melt bonding reinforcement materials to the f...
read more
-
Meltblown cloth is the key material of masks. Meltblown cloth mainly uses polypropylene as the main raw material. Different countries have different standards of the meltblown,and testing method. As key filter material of mask, our meltblown can reach the standard as below: **3-ply surgical mask: European standard: EN 14683 type I / type II / type IIR; American standard: ASTM F2100 level 1/ l...
read more
-
Nowadays there are many ways to filter, and the fabric system is also widely used. Needle punched non-woven fabric is one of the filter materials, which belongs to a fabric medium. It is commonly used in some industrial sectors, such as electronics, food, oxygen production, medicine, etc., as well as the requirements of hotels in terms of air dust and sanitation, mainly to lay low concentration du...
read more
-
To maintain the working efficiency of the melt-blowout machine and reduce the resistance of the melt-blowout cloth as far as possible has become a new issue to be solved by the melt-blowout cloth factory. For example, for a 25g meltblown cloth, single-layer resistance can be controlled below 60pa at a flow rate of 85L/min, double-layer resistance can be controlled below 120pa, single-layer resista...
read more
ipv6 network supported